![]() Again, let it dry completely before moving on to the next step. ![]() This time, however, you’ll want to apply a slightly thicker layer. Step 4: Apply the Second Coat (and Third, and Fourth)Īpply a second coat of joint compound using the same technique as the first coat. It’s a bit difficult to know how much to sand if this is your first time trying to skim coat. Be careful not to sand too much, as you don’t want to remove too much of the joint compound. Once the first coat is dry, use 120-grit sandpaper to sand it down until it’s smooth and even. This is where the repetitive portion of this home improvement task comes in. This can take anywhere from 2-24 hours, depending on the humidity and temperature in your room. Be sure to smooth out any ridges or bumps as you go. Start with a small section and work your way around the room. You don’t need to cover the entire wall in one go. Using a drywall knife, apply the joint compound to the wall in thin, even strokes. You’ll want it to be the consistency of thick paint. Then, you’ll want to follow the manufacturer’s instructions to mix the joint compound. If you’re working with bare drywall, you can skip this step. If you’re working with walls that have wallpaper or paint, you’ll need to remove it first. Drop cloths or plastic sheeting (to protect floors and furniture)īefore you begin your Denver skim coating project, make sure your walls are clean and free of any dust, dirt, or debris. ![]() Joint compound (also called drywall compound).In this beginner’s guide, we’ll walk you through the steps to skim coat your walls and achieve a professional-looking finish. It’s a great way to prep walls for painting or wallpapering, and it can also be used to repair small cracks and imperfections. Skim coating is the process of applying a thin layer of joint compound to a wall to create a smooth, even surface. If you’re looking to smooth out walls that have been damaged, textured, or are just uneven, then skim coating might be the solution for you. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |